Pic Update as @ 11/01/10
Moderators: IMC, Club Staff
- rock_it
- Oldtimer
- Posts: 6599
- jedwabna poszewka promocja
- Joined: Sun Jun 10, 2007 5:00 pm
- Location: The Shire .. NSW
- Contact:
Pic Update as @ 11/01/10
Hi all,
Well, I was able to load up some new pics on my cardomain page, and since I can't access photbucket at work I will link them this way ...
Here are the pics of the bar courtesy of Dwayne ... Considering my front fender is a bit out of alignment (from the little accident a while ago), this bar has pretty much fit straight on with little fuss... Aza and I attacked each others cars a few weeks ago to fit them ... So big thanks to Aza for his help too...
Hopefully to be painted in the next week or so ... With a few little additions here and there... I think I have set the coilovers to have 11-12cm of ground clearance from the lowest point of the bar... Which are those little pod parts at the front...
Well, I was able to load up some new pics on my cardomain page, and since I can't access photbucket at work I will link them this way ...
Here are the pics of the bar courtesy of Dwayne ... Considering my front fender is a bit out of alignment (from the little accident a while ago), this bar has pretty much fit straight on with little fuss... Aza and I attacked each others cars a few weeks ago to fit them ... So big thanks to Aza for his help too...
Hopefully to be painted in the next week or so ... With a few little additions here and there... I think I have set the coilovers to have 11-12cm of ground clearance from the lowest point of the bar... Which are those little pod parts at the front...
Last edited by rock_it on Wed Jan 13, 2010 3:50 pm, edited 1 time in total.
I just had to add it ......
sublime19 wrote:Lol clearly you don't know me well enough, it was a joke
I talk a lot of sh*t, usually have to keep a roll of toilet paper handy in the car for my mouth
Astron_Boy wrote:Hold me Sooty, I need man comfort.
- vipfto
- Forum Moderator
- Posts: 4154
- Joined: Mon Oct 29, 2007 5:00 pm
- Location: Adelaide
- rock_it
- Oldtimer
- Posts: 6599
- Joined: Sun Jun 10, 2007 5:00 pm
- Location: The Shire .. NSW
- Contact:
Actually, when it is on flat ground, the back is higher then the front ...
I think we have close to 20cm clearance from the lowest part of the rear.. It is also that the tyres on the rear are 235's when the front are 215's... So the guard does not get full up with tyre...
As the fronts are only new, when they wear out, they will get 225's while the rear will remain with 235's ..
I think we have close to 20cm clearance from the lowest part of the rear.. It is also that the tyres on the rear are 235's when the front are 215's... So the guard does not get full up with tyre...
As the fronts are only new, when they wear out, they will get 225's while the rear will remain with 235's ..
I just had to add it ......
sublime19 wrote:Lol clearly you don't know me well enough, it was a joke
I talk a lot of sh*t, usually have to keep a roll of toilet paper handy in the car for my mouth
Astron_Boy wrote:Hold me Sooty, I need man comfort.
- El_Ade
- Grease Monkey
- Posts: 163
- Joined: Sun Nov 01, 2009 5:00 pm
- Location: Brizzy
- Contact:
- I8A4RE
- QLD Coordinator
- Posts: 9594
- Joined: Mon Aug 28, 2006 5:00 pm
- Location: BOOSTIN in front of you
- Contact:
- rock_it
- Oldtimer
- Posts: 6599
- Joined: Sun Jun 10, 2007 5:00 pm
- Location: The Shire .. NSW
- Contact:
It is the VersionR (or Facelift front bar) that is blended with a T's Factory lip... There is the group buy threas started by Dstocks here ... I am pretty sure he still has some left, so get in now if you want one... Cheap price, and it really is a great build ... It literally just lines straight up ...El_Ade wrote:Looks good man!
What front bumper is that?
Blahahaha ... But missing the chopped bar and intercooler... I remember the photo you are talking about though... It had stock Nissan rims on it ... Maybe that is why I got the secret question wrong... Blahahahahah ...I8A4RE wrote:Geez, i though i was looking at sams car for a minute....... You know that carbon bonnet and 2 DIFFERENT RIMS lol.
Nah looks wicked man, nice work
(and since this is my thread I can go off topic) ... What is this I was reading about you not making the bonfire ..... C'mon man ...
I just had to add it ......
sublime19 wrote:Lol clearly you don't know me well enough, it was a joke
I talk a lot of sh*t, usually have to keep a roll of toilet paper handy in the car for my mouth
Astron_Boy wrote:Hold me Sooty, I need man comfort.
- aza013
- NSW Coordinator
- Posts: 9087
- Joined: Mon Mar 26, 2007 5:00 pm
- Location: The Shire
- Contact:
- koolio1234
- Oldtimer
- Posts: 2574
- Joined: Sat Oct 04, 2008 5:00 pm
- Location: Western Sydney
- Contact:
- rock_it
- Oldtimer
- Posts: 6599
- Joined: Sun Jun 10, 2007 5:00 pm
- Location: The Shire .. NSW
- Contact:
Thanks guys... I must admit, I can't stop looking @ her...
Lol @ J ... Would love to put her lower, but I like being able to get out of my driveway... And going to the shops...
Lol @ J ... Would love to put her lower, but I like being able to get out of my driveway... And going to the shops...
I just had to add it ......
sublime19 wrote:Lol clearly you don't know me well enough, it was a joke
I talk a lot of sh*t, usually have to keep a roll of toilet paper handy in the car for my mouth
Astron_Boy wrote:Hold me Sooty, I need man comfort.
- J
- Oldtimer
- Posts: 2182
- Joined: Fri Apr 18, 2008 5:00 pm
- Location: Sydney West
- Contact:
muahaha just do what i do, angle up, reverse straight, angle again... repeat if need be... OR long angle through the neighboors grassrock_it wrote:Thanks guys... I must admit, I can't stop looking @ her...
Lol @ J ... Would love to put her lower, but I like being able to get out of my driveway... And going to the shops...
cant wait to get my bc coils in...
- rock_it
- Oldtimer
- Posts: 6599
- Joined: Sun Jun 10, 2007 5:00 pm
- Location: The Shire .. NSW
- Contact:
Which BC's did you get ... The normal ones, or the Golds... ???J wrote:muahaha just do what i do, angle up, reverse straight, angle again... repeat if need be... OR long angle through the neighboors grassrock_it wrote:Thanks guys... I must admit, I can't stop looking @ her...
Lol @ J ... Would love to put her lower, but I like being able to get out of my driveway... And going to the shops...
cant wait to get my bc coils in...
I just had to add it ......
sublime19 wrote:Lol clearly you don't know me well enough, it was a joke
I talk a lot of sh*t, usually have to keep a roll of toilet paper handy in the car for my mouth
Astron_Boy wrote:Hold me Sooty, I need man comfort.
- J
- Oldtimer
- Posts: 2182
- Joined: Fri Apr 18, 2008 5:00 pm
- Location: Sydney West
- Contact:
havnt recieved them yet, they wont go in till i wear out my front tyres. got 235/45/18 on the fronts and they just make it under the fender. thats with fender lipping and pulling and some bashing to the wheel wells.
215/35/18 will go on next and then low
good to see your cf bonnet didnt get too damaged from the accident aswell
215/35/18 will go on next and then low
good to see your cf bonnet didnt get too damaged from the accident aswell
- rock_it
- Oldtimer
- Posts: 6599
- Joined: Sun Jun 10, 2007 5:00 pm
- Location: The Shire .. NSW
- Contact:
Yeah.. It held up pretty well ... Only damage was due to her spare tyre sitting on it ...
You sure you want 215's ... I have them on mine, and with the coilovers it is a real bumpy ride... Which is why I want the 225 front and 235 rear ... Give a bit more of a cushion ... I have heard the BC's are pretty rough too ...
You getting em from Just Jap
If so, let me know, and I can pick em up for you ... Unless you are going there yourself .. But either way, would still like to check em out...
You sure you want 215's ... I have them on mine, and with the coilovers it is a real bumpy ride... Which is why I want the 225 front and 235 rear ... Give a bit more of a cushion ... I have heard the BC's are pretty rough too ...
You getting em from Just Jap
If so, let me know, and I can pick em up for you ... Unless you are going there yourself .. But either way, would still like to check em out...
I just had to add it ......
sublime19 wrote:Lol clearly you don't know me well enough, it was a joke
I talk a lot of sh*t, usually have to keep a roll of toilet paper handy in the car for my mouth
Astron_Boy wrote:Hold me Sooty, I need man comfort.
- I8A4RE
- QLD Coordinator
- Posts: 9594
- Joined: Mon Aug 28, 2006 5:00 pm
- Location: BOOSTIN in front of you
- Contact:
- rock_it
- Oldtimer
- Posts: 6599
- Joined: Sun Jun 10, 2007 5:00 pm
- Location: The Shire .. NSW
- Contact:
Dropping her off at the panel shop on this coming Saturday ..
Hopefully it will be finished by Australia Day, but knowing my luck it wont... Ohhh well ... What can you do ..
I would say more then likely it will be ready by the next weekend ... Lets see how it goes.. Going to be doing a couple of things while it is in there ...
Hopefully it will be finished by Australia Day, but knowing my luck it wont... Ohhh well ... What can you do ..
I would say more then likely it will be ready by the next weekend ... Lets see how it goes.. Going to be doing a couple of things while it is in there ...
I just had to add it ......
sublime19 wrote:Lol clearly you don't know me well enough, it was a joke
I talk a lot of sh*t, usually have to keep a roll of toilet paper handy in the car for my mouth
Astron_Boy wrote:Hold me Sooty, I need man comfort.
- J
- Oldtimer
- Posts: 2182
- Joined: Fri Apr 18, 2008 5:00 pm
- Location: Sydney West
- Contact:
no not from just jap, i thought they only sold the streets (red/black sets)rock_it wrote:Yeah.. It held up pretty well ... Only damage was due to her spare tyre sitting on it ...
You sure you want 215's ... I have them on mine, and with the coilovers it is a real bumpy ride... Which is why I want the 225 front and 235 rear ... Give a bit more of a cushion ... I have heard the BC's are pretty rough too ...
You getting em from Just Jap
If so, let me know, and I can pick em up for you ... Unless you are going there yourself .. But either way, would still like to check em out...
i can always change spring rates if its too ruff. but if it cant be allot more teeth jarring then mine now. honestly i can live with it
with tyres i'll still go 215/35 or 215/45... reason for this is for the stretch over the wheel so i can get better wheel fitment.