Mivec Controller & Turbo?

d_dan · Post by **d_dan** » Fri Jun 10, 2011 6:40 am

Just wondering has anyone used a mivec controller along with a 6A12 turbo conversion?

Im just wondering if anyone could tell me if its worth it?
My car is to run,
Fully forged internals,
vernier cam gears,
a VF35 turbo

Also the car is a track car so fuel economy isn't an issue for me

Post by **Bennoz** » Fri Jun 10, 2011 8:33 am

If you're spending that kind of coin on a track car, just get a Haltech. Mivec controllers are useless. It's been set at the optimum point from factory.

d_dan · Post by **d_dan** » Fri Jun 10, 2011 9:44 am

I already have a piggyback ECU but am wondering if it would be a benefit to alter it

Post by **Bennoz** » Fri Jun 10, 2011 9:49 am

Nah, lots of kids here have tried it, and tried it on dynos etc, best results were obtained at the factory kick in point.

d_dan · Post by **d_dan** » Fri Jun 10, 2011 9:53 am

cool.
Many here with a 6A12T and have altered the cam timing?

Post by **Bennoz** » Fri Jun 10, 2011 10:16 am

Not the 6A12T. I've had success with the 6A13TT though, retarded the exhaust cams by 2 degrees & picked up over 20kws... so I reckon there's every possibility you could on the 12...

d_dan · Post by **d_dan** » Fri Jun 10, 2011 10:46 am

did it save you from loosing much boost?

FTO AUSTRALIA

Mivec Controller & Turbo?

Mivec Controller & Turbo?

Re: Mivec Controller & Turbo?

Re: Mivec Controller & Turbo?

Re: Mivec Controller & Turbo?

Re: Mivec Controller & Turbo?

Re: Mivec Controller & Turbo?

Re: Mivec Controller & Turbo?