camber adjustment, and spacers.

[adzski]

hi guys,

i want to do the following.

i want to put negative camber on the rears, i read on here somewhere that stock they can be cambered to 4 degrees?
also what after market alternatives are there? can you buy camber arms?

ill have to check but i may have camber adjustment on my coilovers.

also i want to run spacers on the rear, im planning on getting the spacers listed below, but maybe not as thick.
http://www.ebay.com.au/itm/2pcs-Wheel-S ... 41732dd316

is the bolt pattern defiantly 5X114.3?

thanks guys

[Technikhaus]

5x114.3 is the stud pattern.

[adzski]

thanks Technikhaus, i thought it might have been just wanted to be sure?

anyone know about the camber questions?
are there aftermarket camber arms for the front?

[ZFL45H1]

Yes you can buy rear camber and toe arms there from hardline racing and also from megan racing Im pretty sure look for evo 1-3

[adzski]

Thanks ZFL45H1.

i think i found the ones your talking about
http://www.ebay.com.au/itm/MEGAN-2pc-Re ... 4d1cf3f2c6

[ZFL45H1]

Yep thats them

[Sahin]

camber plates on the shock on the front is your best bet for camber alignment on the front too

[adzski]

thanks guys. my front coilovers have the adjustable plate. i might have a crack at it tomorrow.

[ZFL45H1]

Just bite the bullet and get a suspension place to do it cause chances are they will be way out of alignment

[Bennoz]

Don't get those spacers, get hub centric ones. Otherwise the load is purely on the studs.

FTO hub is 67.1mm. Try something like these: http://www.ebay.com.au/itm/AF-RACING-Mi ... 73a&_uhb=1

[adzski]

cheers bennoz i will do exactly that. might have to get some made up for the width i want