WTB: gpx manual mivec engine loom

[95luke]

I'm in need of a gpx manual mivec loom for my 6a12 conversion to ce coupe. I have all auto wiring but a manual box so I'm ditching the auto engine loom for a manual one.

Open to all prices nothing too ridiculous post code 4870 will pay for shipping

[Daniel2019]

Can use auto loom on manual engine. Just have to modify slightly to trick car into thinking it's in P/N and get reverse lights going.

[95luke]

Can use auto loom on manual engine. Just have to modify slightly to trick car into thinking it's in P/N and get reverse lights going.

Thanks, I've been told it's difficult to get it to run well though? Is there a topic you could link me to if there is one.

[Daniel2019]

Nup, just drill hole for clutch, install clutch master and lines and stuff, modify loom to suit and she be good to go I suppose. I'll see if I can find a thread.

[SchumieFan]

There are 4 plugs that go to the auto gearbox... on the large Grey plug, bridge the yellow/black wire and the red/black wire and it will run.

I can't remember the colour of the wires to join the reverse sensor on the top of the manual gearbox to the loom but at least it will start

[95luke]

I have the engine already in the car aswell as already doing the manual swap, it's just not getting ignition or anything with the auto loom, probably because I haven't looped it

[95luke]

I looked at the large grey plug and there was no red/black yellow/black wires but there was on the large black plug so I gave it a shot and looped them together... Nothing. Any suggestions?

[bumpak]

If you can wait about 2 weeks i can get you one. Ill be taking it out of my car.