changing inner cv boot

adzski · Post by **adzski** » Thu Aug 06, 2015 11:16 pm

i am changing the inner cv boots this weekend. does anyone no of a guide?

Post by **Bennoz** » Fri Aug 07, 2015 7:52 am

Don't think I've ever seen a DIY for it, it's not too big a job. You essentially have to remove the entire driveshaft though - and you'll need a pair of circlip plyers to be able to remove the inner coupling, so you can slide the old boot off & slide the new one on.

PHIL069 · Post by **PHIL069** » Fri Aug 07, 2015 10:17 am

Take a look through my Galant thread, you will find pictures of me doing this job...
http://ftoaustralia.com/v3/viewtopic.php?f=41&t=28648

adzski · Post by **adzski** » Fri Aug 07, 2015 10:54 am

thanks guys. ill have alook at your thread phil. will let you know how it all goes.

adzski · Post by **adzski** » Mon Aug 10, 2015 3:02 am

finished this tonight. ended up just leaving the inner cv joint still in, and removed the bearings/shaft. then just cleaned and re-greased and put the boot on the shaft & assembled. like bennoz said wasn't too bad of a job.

adzski · Post by **adzski** » Mon Aug 10, 2015 4:16 am

i did a write up on a diy for changing inner cv boot/drive shaft removal.
http://ftoaustralia.com/v3/viewtopic.ph ... 12#p399712

FTO AUSTRALIA

changing inner cv boot

changing inner cv boot

Re: changing inner cv boot

Re: changing inner cv boot

Re: changing inner cv boot

Re: changing inner cv boot

Re: changing inner cv boot