O2 Sensor/ Inlet/Rocker Cover Gaskets / Sparkplugs
Posted: Sat Aug 19, 2017 4:27 pm
Hey guys,
I did post this on the Facebook page but seems the forum would be the ideal place to post.
Just some info my car is a 1995 GPX No ABS/TC - 170 xxx Km's.
I'm split between the Bosch LS602 I can get through ebay but i've also found the Denso OXY1027 from Sparebox (within Aus) 02 Sensors. Would the Denso be okay/Anyone used them before?
Also I've ordered NGK Iridium sparkplugs and while doing them thought id do the gaskets as well. I suspect I have a rocker cover gasket leak and was wanting to chase up the correct gasket/part numbers while the intake is apart.
MD309002 - Rocker Cover Gasket ?
MD175776 - Inlet Manifold?
As for adjusting tappets on my GPX, Where would this sit in the order of doing things? (kind of a stupid question but before putting in new gaskets and sparkplugs? I don't feel experienced enough to tackle on the diy so I'lll most likely take it to a shop unless someone mobile is able to do them. Since i do not have near close to the right tools and the car can't be down for too much longer.
Finally, if the manifold is off is there anything else i can replace? (Spark plug seals etc). I may need part numbers for individual stuff to get from Amayama since I don't need a full head gasket set which is a bit $$ and unnecessary for me at this point in time.
Thanks
I did post this on the Facebook page but seems the forum would be the ideal place to post.
Just some info my car is a 1995 GPX No ABS/TC - 170 xxx Km's.
I'm split between the Bosch LS602 I can get through ebay but i've also found the Denso OXY1027 from Sparebox (within Aus) 02 Sensors. Would the Denso be okay/Anyone used them before?
Also I've ordered NGK Iridium sparkplugs and while doing them thought id do the gaskets as well. I suspect I have a rocker cover gasket leak and was wanting to chase up the correct gasket/part numbers while the intake is apart.
MD309002 - Rocker Cover Gasket ?
MD175776 - Inlet Manifold?
As for adjusting tappets on my GPX, Where would this sit in the order of doing things? (kind of a stupid question but before putting in new gaskets and sparkplugs? I don't feel experienced enough to tackle on the diy so I'lll most likely take it to a shop unless someone mobile is able to do them. Since i do not have near close to the right tools and the car can't be down for too much longer.
Finally, if the manifold is off is there anything else i can replace? (Spark plug seals etc). I may need part numbers for individual stuff to get from Amayama since I don't need a full head gasket set which is a bit $$ and unnecessary for me at this point in time.
Thanks