Page 1 of 1
DIY: Gear Knob
Posted: Wed Jan 12, 2005 3:03 pm
by alku83
Not much to this one, but I like it. Grab a pool ball, drill a hole in it, then stick a bit of teflon tape around the gear shaft to hold it in.
I've got about 10 spare pool balls if anyone wants one
Posted: Wed Jan 12, 2005 3:44 pm
by smorison
hah nice
i'd probably recommend using a tap (not sure which size) so it can screw on just to make it a little bit more secure
good job
Posted: Wed Jan 12, 2005 3:44 pm
by Boris
Cool!
If you want to get it really good, tap a thread into that drilled hole! But for that you need the special tool!
[EDIT]: Steve beat me, I think the size is 8mm... I think...
Posted: Wed Jan 12, 2005 4:11 pm
by smorison
Boris wrote:Cool!
If you want to get it really good, tap a thread into that drilled hole! But for that you need the special tool!
[EDIT]: Steve beat me, I think the size is 8mm... I think...
i'll be pulling mine apart next week (for different reasons) ... ummm... someone remind me and i will measure it
Posted: Wed Jan 12, 2005 5:47 pm
by alku83
Steve/Boris - I was planning to put a tap in, but I got impatient and couldn't be bothered driving out to Bunnings
I may still put one in, but its a very snug fit with the teflon tape so I might not bother.
And Tanya, not a bad idea
Posted: Thu Jan 13, 2005 10:20 am
by FTO338
very very very nice
, eheheheheh u got a spare black 8 by anychance heehehehehe
Posted: Fri Jan 14, 2005 9:42 am
by alku83
FTO338 wrote:very very very nice
, eheheheheh u got a spare black 8 by anychance heehehehehe
Sorry, I drilled the 8 ball and decided I like the look of it better than the 12
Posted: Sat Jan 15, 2005 2:28 pm
by Boris
To keep this DIY clean, I have split the off topic discussion into another thread.
http://www.ftoaustralia.com/modules.php ... pic&t=4156
I wonder if you could do it with a Golf Ball... Because it would be slightly smaller then the pool ball... it would be similar to this one:
http://www.carmate.co.jp/razo/knob/14.html
Hmm..
Posted: Thu Jul 14, 2005 6:15 pm
by ph3var
Lol just found this thread. I did the 8-ball gear stick mod to me old gemini about 5 years ago and it is still on there nice and strong. But i used a tap and die set to thread the hole in the pool ball.
Didnt think I would find something like this on an FTO site though.