Crossovers
Moderators: IMC, Club Staff
-
- Grease Monkey
- Posts: 254
- jedwabna poszewka promocja
- Joined: Sun Jul 10, 2005 5:00 pm
- Location: "Bristol, that's in Wales isn't it?"
Crossovers
Assuming some of you guys have gone for components in the front, how and where did you fit the crossovers. I'm thinking sticky pads to the door skin or back of the door liner?
-
- Veteran Mechanic
- Posts: 848
- Joined: Tue Sep 10, 2002 5:00 pm
- Location: Brisbane
- Contact:
- FTO338
- Oldtimer
- Posts: 6712
- Joined: Sun Feb 09, 2003 6:00 pm
- Location: Port Melbourne: Pimping with RX400h, B200 Turbo.
Hmmmm that depends how big is your crossover, theres no way mine one can be fitted behind the door or under the head units, so the only option is the boot along with the AMP.
DISCLAIMER: The above text is the personal opinion of the author and does not represent the indisputable truth. The author is not responsible for any deaths, injuries or mental illness caused by the above statments.
- ph3var
- Grease Monkey
- Posts: 222
- Joined: Wed Apr 13, 2005 5:00 pm
- Location: Perth
- Contact:
-
- Grease Monkey
- Posts: 254
- Joined: Sun Jul 10, 2005 5:00 pm
- Location: "Bristol, that's in Wales isn't it?"
-
- Veteran Mechanic
- Posts: 1022
- Joined: Tue Mar 01, 2005 6:00 pm
- Location: Sydney, NSW
When I did the passenger side I hadn't quite thought out the process as much as I should have. Put the crossover in a bag, sealed it and ductaped it to the inside of the door, directly below the speaker mount. Not the best spot but it'll do for now.
For the drivers side I attached it to the backside of the plastic trim directly under the steering wheel (the one you have to remove to get to the door grommet). Plenty of room.
If I were to do the passenger side again (which I will) i'll be putting the crossover in/behind/near the glovebox.
For the drivers side I attached it to the backside of the plastic trim directly under the steering wheel (the one you have to remove to get to the door grommet). Plenty of room.
If I were to do the passenger side again (which I will) i'll be putting the crossover in/behind/near the glovebox.