FTO AUSTRALIA

Taz wrote:And Jack - loving the new profile pic over the one, no half destroyed front bar distracting you lmfao

I know right? It's tactically hiding my shame

ObsidianRadio wrote:

Taz wrote:And Jack - loving the new profile pic over the one, no half destroyed front bar distracting you lmfao

I know right? It's tactically hiding my shame

However if you look closely you can see the massive dent in his rear....

kiz wrote:

ObsidianRadio wrote:

Taz wrote:And Jack - loving the new profile pic over the one, no half destroyed front bar distracting you lmfao

I know right? It's tactically hiding my shame

However if you look closely you can see the massive dent in his rear....

Why do you think I edited it?

ObsidianRadio wrote:

kiz wrote:

ObsidianRadio wrote:

Taz wrote:And Jack - loving the new profile pic over the one, no half destroyed front bar distracting you lmfao

I know right? It's tactically hiding my shame

However if you look closely you can see the massive dent in his rear....

Why do you think I edited it?

Next thing on the market: Instgram IRL. Filter reality! (tm)

It is also showing your fart cannon. Maybe try a side on shot?

I've ordered my timing belt kit from Camskill, and decided to throw in a set of Magnecor leads since it was in my postage limit Didn't realise our aussie dollar was so strong, only paid $230 AUD for the lot including shipping!

HATERS GONNA HATE.

So I attempted the DIY wipers and vent things, turned out quite well me thinks! The blades had previously been painted red and whoever did it did a shocking job...Wasn't even primed and the paint had run really badly, looked awful...Looks sooo much better!

OH and i wont even question this one

Taz wrote:OH and i wont even question this one

HAHAHAHAHAHAHA.

As my facebook post stated, I came back to this after work today

hahaaha classic!
nice job on the wiper drain thing and the blades i did myn a while ago. looks 10x better! keep up the mods hahah
oh and nice veilside sticker! reminds of the fully sick drifties rx7 in tokyo drift

adzski wrote:hahaaha classic!
nice job on the wiper drain thing and the blades i did myn a while ago. looks 10x better! keep up the most hahah
oh and nice veilside sticker! reminds of the fully sick drifties rx7 in tokyo drift

I actually bought it no less than 10 minutes after watching that film. Hahahahaha!

So my time has come to finally be rid of the old wheels and get some new ones!

The only problems are A) I'm on a budget of give or take $1500 including tyres and B) I don't know what to get!

I'm wanting to get something brand new, preferably from Bob Jane, tyre centre etc, so I don't have to f**k around with postage and second hand issues. I've had a browse and I found around 8 sets that I think look good on my car... What should I get?!

CSA Razor Black/Machined Face
CSA Speedster Black/Machined Face
Enix Wheels Senator Black/Machined
Osaka Wheels Chaser Black/Machined
Ox Wheels 626 Black/Machined
Osaka Wheels RS5 Black/Machined Lip
Ox Wheels 801 Matte Black
PDW Wheels Fuzion Black/Machined Lip

If anybody has the time to look these up and tell me what you think... Let me know your opinions!

i had a look through all and i prefer the Osaka Chaser wheels

however i only like that rim cause its close to the style of rims i like, like these
http://www.ebay.com.au/itm/Set-4-ADVAN- ... 2c68155a19

just a suggestion u might like these rims seems close to the style of rim you like
http://www.ebay.com.au/itm/4x-ADVAN-TCI ... 2c66686957

My faves so far are probably the Enix Senator... Will I be needing to make any modifications to my FTO should I want 18s? The Bob Jane site says they come in 17 but all other sites say 18 is minimum size...

http://www.google.com.au/imgres?um=1&hl ... 66&bih=645

on bob jane site says

18" 8.0" 38 5
they should go straight on some one correct me if im wrong!

one of the guys that commented on my thread ages ago about rims said his 18s never scrub his rim dimensions were
18" x 7.5" with +42 offset. not sure about the tyres though

So I have a $1500 budget!! Got the cash all good to go now, but I'm still trying to pick!! I'm currently looking at Sparco RP03s or Gmax Drift 6...


What's everybody's opinions? I'm also thinking of Enkeis as well, but I can't get anything too pricey...