FTO AUSTRALIA

Should be a bracket the pedal sits in the master has the two bolts through fire wall and one bolt inside cabin behind dash near steering column. Bitch to put in

You've only got half a pedal assembly mate.. lol

Assembly should be here tomorow
However, it has come to my attention that drilling the holes through the firewall is going to be very tricky and very costly if I f**k it up.
Likelihood of me f**king it up....hmmm. Based on the facts
I only get one try at it
The guide I have is very very basic in explaining it.
It's the last step
The position is very difficult to get to with a drill
And because its just me in particular ... The chances are moderatelyhighly possiblelikely that I shall .f**k.It.UP.
I'd like to bring it down too low or 50/50 at least
For Anyone that has done this, it would be very VERY much appreciated if you could walk me through it with a step by step write up(with a few pics would be fuking brilliant) but all and any genuine help would be great. THANKYOU

Done it. If motor in car try lower it by removing side mount there is actually a flat on firewall that you drill through. Will be easier if you make a template too. Don't worry if not perfect once all bolted up inside cabin and on wall it will be fine

Need more pictures for reference?

vipfto wrote:Done it. If motor in car try lower it by removing side mount there is actually a flat on firewall that you drill through. Will be easier if you make a template too. Don't worry if not perfect once all bolted up inside cabin and on wall it will be fine

Really... Does it have to be drilled from inside the cabin? Or easier to lower the engine and do it from the outside?

No I mean lower engine do from outside lol be impossible to do from cabin. You'll be fine dont stress over it,

vipfto wrote:No I mean lower engine do from outside lol be impossible to do from cabin. You'll be fine dont stress over it,

How do I no where to drill from the outside though? The arm has to come through and attach to the pedal.. If its off the slightest then it won't connect

Yeah it will there is a flat on firewall ill take pic tomorrow but its installed so may not help much

FTOwnage wrote:Need more pictures for reference?

Yes thanks! It's a hard spot to get a photo of though.

vipfto wrote:Yeah it will there is a flat on firewall ill take pic tomorrow but its installed so may not help much

Next to the brake booster yeah?
Yep a photo wil help a lot cheers man!

I'll get onto it tomorrow.

How about some pictures of those Project F's in the mean time ?

FTOwnage wrote:I'll get onto it tomorrow.

How about some pictures of those Project F's in the mean time ?

Thanks!

Will do Tomorow aswell ,when there's good light.

Could someone check to see what hole the top stud goes through on their pedal bracket please?

There is a stud where it goes through then put nut over too tighten

vipfto wrote:There is a stud where it goes through then put nut over too tighten

Yep but what hole does the stud go through? The end one or the second one?

Top from memory

vipfto wrote:Top from memory

yeah so i fucked it up.
going to cut the square out and then makeup a plate (with the holes for the cylinder allready cut) and bolt it to the wall. get it welded on later.

How'd you f**k it up?

i dont wantto talk about it