FTO AUSTRALIA

Ok, my passengers side seat bolt broke when i was tightening it.
I got a bolt remove kit for the drill, but when i drill into the bolt it ain't doing sh*t! any reasons why?

And if not

where do you think i could go to get the bolt removed with out them killing my seat? URGENT!

here is a pic of what bolt broke.

You mean bolt remove kit as in an 'easy-out'?

If so, you dont go putting that on a full speed drill, its a slow hand turn operation....

Didn't Just Cars get it fixed for you? What else have you tried? Will pliers not do the job?

mr-charisma wrote:Didn't Just Cars get it fixed for you? What else have you tried? Will pliers not do the job?

yeah got her back friday i broke the bolt before i crashed my car.

i got a screw extractor set. but it doesn't do sh*t all
any idea on what kit i should get then?

use a drill with a metal drill bit

jonowong wrote:use a drill with a metal drill bit

and go slow so u dont slip and drill a hole in to your seat.

or i guess u can go to any mechnanics and ask them to rape u with a nice pretty over priced bill to remove it

what do i do once i drill into it :S

If you've managed to drill a starting hole in the middle use the easy out and turn it by hand in a counter clock wise? direction to get the bolt out.

Don't you hate when this happens. DId this the other week due to a torque wrench that broke as I did something up. Unfortunately it was a high tensil screw and small so I couldn't get a starting hole going. In the end I just used a bigger drill and drilled it out and used a dye to cut a new thread. It worked thank god.

--------------------------------------------------------------------------------


For christ sake don't put to much force on that easyout.
If you snap that thing off in the bolt then you are trully f***ked. You"ll never drill that out.
Dave O

ahhaha ok guys i will have to do this on the weekend. so i will see how i go.