Page 1 of 2
FS: 6a12 twinturbo parts
Posted: Fri Jan 15, 2010 4:53 pm
by Nemesis
parting out my project engine.
stock non mivec heads, $200
tt nitrided crankshaft, $150
rods, $80
turbo manifolds, $150
turbo's, $100 pair
anything else from the engine of interest (water cooled oil cooler, inlet manifolds, throttle body) let me know, must go asap.
Posted: Fri Jan 15, 2010 5:42 pm
by Tippin
pics of your setup please
Posted: Fri Jan 15, 2010 6:28 pm
by Nemesis
it's just a stock factory vr4 tt setup.
Posted: Fri Jan 22, 2010 4:48 pm
by Nemesis
goes to the bin then I suppose.
Posted: Fri Jan 22, 2010 5:07 pm
by Bennoz
Where are you located?
Posted: Fri Jan 22, 2010 5:17 pm
by Astron_Boy
What turbos?
vr4 ones with the 3 bolt?
Posted: Fri Jan 22, 2010 5:32 pm
by Nemesis
located in townsville qld.
turbo's are the 3 bolt vr4 or tdo25l or m, cant remember which.
Posted: Fri Jan 22, 2010 6:42 pm
by Astron_Boy
damn.
oh well, good luck with sale.
Posted: Tue Jan 26, 2010 1:37 pm
by Nemesis
whole engine for $250, just need it out of my shed, have a new project and need the space.
Posted: Fri Jan 29, 2010 9:21 pm
by Nemesis
bump, still here.
Posted: Sat Jan 30, 2010 2:09 pm
by koolio1234
Do you have the air intake manifold?
Posted: Sun Jan 31, 2010 11:37 am
by Nemesis
yes I still have the whole engine
Posted: Sun Jan 31, 2010 12:53 pm
by nathan
where are you located?
Posted: Sun Jan 31, 2010 7:03 pm
by Nemesis
townsville
Posted: Wed Feb 03, 2010 5:54 pm
by Nemesis
Posted: Wed Feb 03, 2010 8:59 pm
by AMACHA
Can Bennoz or any other old timers confirm that any of these parts are strengthed over the stock gpx parts and if they willl fit a gpx engine?
Posted: Thu Feb 04, 2010 9:53 am
by I8A4RE
Did you read the whole thread???
We believe they may fit but arent completely sure but mate for $250 bucks you cant go wrong
Posted: Wed Feb 10, 2010 6:04 pm
by Nemesis
still here, need it gone, seriously low on space.
Posted: Sat Feb 13, 2010 9:40 am
by nathan
maybe a silly question but would you freight it?
keen on that crankshaft lol
Posted: Sat Feb 13, 2010 2:18 pm
by Nemesis
would prefer pickup, if you organise freight I can drop it off at a depot.
it's already sitting on a skid, would just need to strap it down and send a box of bits along with it.
