FTO AUSTRALIA

Posted: **Tue Mar 19, 2013 7:55 pm**

Posted: **Tue Mar 19, 2013 9:32 pm**

Ooh. Wondered what the landed cost would be... despite the fact I can't afford them.

Posted: **Tue Mar 19, 2013 9:34 pm**

If we get a group buy in and fill a container full of JDM rims its highly possible.

Whos in?

1.silverGPX

Posted: **Tue Mar 19, 2013 10:24 pm**

silverGPX wrote:If we get a group buy in and fill a container full of JDM rims its highly possible.

Whos in?

1.silverGPX

That sounds like a plan..

Posted: **Wed Mar 20, 2013 6:40 am**

I pay $250 for a landed facelift bumper from japan so two I would assume would set you back around the $550 mark.

Posted: **Wed Mar 20, 2013 7:18 am**

Ive cut one in half to send and rejoined it when it arrived. Saved a lot on postage.

Posted: **Wed Mar 20, 2013 9:00 am**

dstocks wrote:Ive cut one in half to send and rejoined it when it arrived. Saved a lot on postage.

How did you manage that? Melt them back together lol?

Posted: **Wed Mar 20, 2013 4:09 pm**

^Zip tie + duct tape

Posted: **Wed Mar 20, 2013 4:26 pm**

phunkydude wrote:^Zip tie + duct tape

Its called fiberglass....

Posted: **Wed Mar 20, 2013 4:29 pm**

Taz wrote:
phunkydude wrote:^Zip tie + duct tape

Its called fiberglass....

Taz dont be a noob, clearly it was just sikaflex and bluetak. Derp.

Back to the thread, good find. If I had money I'd get the front bar

Posted: **Wed Mar 20, 2013 9:12 pm**

I know Nick (The real Technikhaus) Is quite keen on this, his dream front bumper is the ProjectF...

Project F front and rear bumper Yahoo Japan