FTO AUSTRALIA

hi guys,

i want to do the following.

i want to put negative camber on the rears, i read on here somewhere that stock they can be cambered to 4 degrees?
also what after market alternatives are there? can you buy camber arms?

ill have to check but i may have camber adjustment on my coilovers.

also i want to run spacers on the rear, im planning on getting the spacers listed below, but maybe not as thick.
http://www.ebay.com.au/itm/2pcs-Wheel-S ... 41732dd316

is the bolt pattern defiantly 5X114.3?

thanks guys

5x114.3 is the stud pattern.

thanks Technikhaus, i thought it might have been just wanted to be sure?

anyone know about the camber questions?
are there aftermarket camber arms for the front?

Yes you can buy rear camber and toe arms there from hardline racing and also from megan racing Im pretty sure look for evo 1-3

Thanks ZFL45H1.

i think i found the ones your talking about
http://www.ebay.com.au/itm/MEGAN-2pc-Re ... 4d1cf3f2c6

Yep thats them

camber plates on the shock on the front is your best bet for camber alignment on the front too

thanks guys. my front coilovers have the adjustable plate. i might have a crack at it tomorrow.

Just bite the bullet and get a suspension place to do it cause chances are they will be way out of alignment

Don't get those spacers, get hub centric ones. Otherwise the load is purely on the studs.

FTO hub is 67.1mm. Try something like these: http://www.ebay.com.au/itm/AF-RACING-Mi ... 73a&_uhb=1

cheers bennoz i will do exactly that. might have to get some made up for the width i want