FTO AUSTRALIA

I'm in need of a gpx manual mivec loom for my 6a12 conversion to ce coupe. I have all auto wiring but a manual box so I'm ditching the auto engine loom for a manual one.

Open to all prices nothing too ridiculous post code 4870 will pay for shipping

Can use auto loom on manual engine. Just have to modify slightly to trick car into thinking it's in P/N and get reverse lights going.

Daniel2019 wrote:Can use auto loom on manual engine. Just have to modify slightly to trick car into thinking it's in P/N and get reverse lights going.

Thanks, I've been told it's difficult to get it to run well though? Is there a topic you could link me to if there is one.

Nup, just drill hole for clutch, install clutch master and lines and stuff, modify loom to suit and she be good to go I suppose. I'll see if I can find a thread.

There are 4 plugs that go to the auto gearbox... on the large Grey plug, bridge the yellow/black wire and the red/black wire and it will run.

I can't remember the colour of the wires to join the reverse sensor on the top of the manual gearbox to the loom but at least it will start

I have the engine already in the car aswell as already doing the manual swap, it's just not getting ignition or anything with the auto loom, probably because I haven't looped it

I looked at the large grey plug and there was no red/black yellow/black wires but there was on the large black plug so I gave it a shot and looped them together... Nothing. Any suggestions?

If you can wait about 2 weeks i can get you one. Ill be taking it out of my car.