FTO AUSTRALIA

hi, i just bought my fto. its got a mivec hand controller (R Spec MVC85X ). Its got a function by which u can change the number of cylinders in use. how do i find this function and how do i change the number of cylinders through mivec controller? please help.

Here you go Clicky->http://www.boomspeed.com/spykey/RSVTC.html

THANKS HEAPS FOR THE SITE. The site that you have given me is for some other miver controller. my mivec controller is different from what that site has. its model number is R Spec MVC85X. do you know where i can find a manual on how to use this controller. thanks again for helpin

The manual for your mivec controller is no longer availible, i thought this would be similar to yours & it might help. Sorry mate

Here it is:
http://www.mitsubishi-fto.org/parts/ele ... mvc85x.htm

Just a note, to set the cylinders etc, push both the arrows together and to exit the setup mode push the other two together.

Hope it helps

doesn't mivec controller just slow down your car?

Not neccesaraly. Only if you change it to an obsurd Rev point.
I leave mine on stock.

Or say when your gf drives, change it to 8k

Boris wrote:Or say when your gf drives, change it to 8k

Lol... you didn't did you Boris?

Bennoz wrote:

Boris wrote:Or say when your gf drives, change it to 8k

Lol... you didn't did you Boris?

Nah
She drives my car like a grandma anyway

You ain't seen granny-driving until you've seen me on public roads...

Your g/f would zoom by me in an instant...

- Rich

can't be worst then me, if you ever see a stupid silver with a GPvR front GT-wing like a turtle on the road, it have to be me

this is prolly what your lookin for vivek check it out
http://www.mitsubishi-fto.org/parts/ele ... mvc85x.htm

might answer a few questions for u

woah thanks people. this forum is awesome. found that my cylinder was setings in ma mivec was stuck at 4 when it should be 6. now i've changed it back to 6. thanks heaps. now get ma exhaust done for max power.