hi Guys,
After 71k genuine miles on my fto it's time to check and adjust the valve clearance on my GPX. I have done this multiple times on hondas but never did this on a mivec so i checked the web for instructions. i found the workshop manual which clearly instructs to set the piston at TDC. (Cam lobes pointing away from each other or towards each other depending on which cilinder head you work on, rear or front)
However.. the instruction at https://ftoworx.files.wordpress.com/201 ... appets.pdf states that i have to ensure that the nose of the cam lobe for the valves you’re adjusting is vertical, relative to the cam carrier.
I am confused now
please help!
KR
Eric
Adjusting valve clearance
Moderators: IMC, Club Staff
- flateric
- Apprentice
- Posts: 41
- jedwabna poszewka promocja
- Joined: Sat Apr 06, 2013 12:38 pm
Adjusting valve clearance
if it doesn't brake just hit the gas
----------------------------------------
Audi A6 avant 1.9 tdi - 175HP
Honda CRX 1986 - 130 HP
Mitsubishi FTO 1996 - 200HP
----------------------------------------
Audi A6 avant 1.9 tdi - 175HP
Honda CRX 1986 - 130 HP
Mitsubishi FTO 1996 - 200HP
- Sahin
- HULK
- Posts: 5518
- Joined: Wed Oct 05, 2011 10:38 pm
- Location: Up to me nuts in boys guts
Re: Adjusting valve clearance
Doesn't matter where the cams lobes are located as long as it isn't under load on the one you're adjusting...
- Daniel2019
- Oldtimer
- Posts: 7957
- Joined: Thu Jan 12, 2012 12:25 pm
- Location: Sydney!
- Contact:
Re: Adjusting valve clearance
Doesn't have to be vertical but for organization's sake and keeping it simple, follow the manual.
I fix cars.
Bennoz wrote:I got Bali beli & sharted on my phone. But it was fun
bjk wrote:you old people are no help at all.
- flateric
- Apprentice
- Posts: 41
- Joined: Sat Apr 06, 2013 12:38 pm
Re: Adjusting valve clearance
ok that makes sense to me. the manual states TDC so not vertical. cam lobes either pointing away from each other or towards (not under load and both valves closed).
thanks!
thanks!
if it doesn't brake just hit the gas
----------------------------------------
Audi A6 avant 1.9 tdi - 175HP
Honda CRX 1986 - 130 HP
Mitsubishi FTO 1996 - 200HP
----------------------------------------
Audi A6 avant 1.9 tdi - 175HP
Honda CRX 1986 - 130 HP
Mitsubishi FTO 1996 - 200HP
- spetz
- Oldtimer
- Posts: 2915
- Joined: Wed Mar 03, 2004 6:00 pm
Re: Adjusting valve clearance
I've not looked into this however will be adjusting my tappets as I'll be replacing my valve stem seals, however in my mind the clearances must be set at the engine position where the camshaft is on its lowest axis (ie, off the lobe) relative to the valve.
Would this be correct?
Would this be correct?
- Daniel2019
- Oldtimer
- Posts: 7957
- Joined: Thu Jan 12, 2012 12:25 pm
- Location: Sydney!
- Contact:
Re: Adjusting valve clearance
No sh*t
I fix cars.
Bennoz wrote:I got Bali beli & sharted on my phone. But it was fun
bjk wrote:you old people are no help at all.