FS: 6a12 twinturbo parts

Nemesis · Post by **Nemesis** » Fri Jan 15, 2010 4:53 pm

parting out my project engine.

stock non mivec heads, $200

tt nitrided crankshaft, $150

rods, $80

turbo manifolds, $150

turbo's, $100 pair

anything else from the engine of interest (water cooled oil cooler, inlet manifolds, throttle body) let me know, must go asap.

Tippin · Post by **Tippin** » Fri Jan 15, 2010 5:42 pm

pics of your setup please

Nemesis · Post by **Nemesis** » Fri Jan 15, 2010 6:28 pm

it's just a stock factory vr4 tt setup.

Nemesis · Post by **Nemesis** » Fri Jan 22, 2010 4:48 pm

goes to the bin then I suppose.

Post by **Bennoz** » Fri Jan 22, 2010 5:07 pm

Where are you located?

Astron_Boy · Post by **Astron_Boy** » Fri Jan 22, 2010 5:17 pm

What turbos?
vr4 ones with the 3 bolt?

Nemesis · Post by **Nemesis** » Fri Jan 22, 2010 5:32 pm

located in townsville qld.

turbo's are the 3 bolt vr4 or tdo25l or m, cant remember which.

Astron_Boy · Post by **Astron_Boy** » Fri Jan 22, 2010 6:42 pm

damn.
oh well, good luck with sale.

Nemesis · Post by **Nemesis** » Tue Jan 26, 2010 1:37 pm

whole engine for $250, just need it out of my shed, have a new project and need the space.

Nemesis · Post by **Nemesis** » Fri Jan 29, 2010 9:21 pm

bump, still here.

koolio1234 · Post by **koolio1234** » Sat Jan 30, 2010 2:09 pm

Do you have the air intake manifold?

Nemesis · Post by **Nemesis** » Sun Jan 31, 2010 11:37 am

yes I still have the whole engine

nathan · Post by **nathan** » Sun Jan 31, 2010 12:53 pm

where are you located?

Nemesis · Post by **Nemesis** » Sun Jan 31, 2010 7:03 pm

townsville

Nemesis · Post by **Nemesis** » Wed Feb 03, 2010 5:54 pm

AMACHA · Post by **AMACHA** » Wed Feb 03, 2010 8:59 pm

Can Bennoz or any other old timers confirm that any of these parts are strengthed over the stock gpx parts and if they willl fit a gpx engine?

Post by **I8A4RE** » Thu Feb 04, 2010 9:53 am

Did you read the whole thread???

We believe they may fit but arent completely sure but mate for $250 bucks you cant go wrong

Nemesis · Post by **Nemesis** » Wed Feb 10, 2010 6:04 pm

still here, need it gone, seriously low on space.

nathan · Post by **nathan** » Sat Feb 13, 2010 9:40 am

maybe a silly question but would you freight it?

keen on that crankshaft lol

Nemesis · Post by **Nemesis** » Sat Feb 13, 2010 2:18 pm

would prefer pickup, if you organise freight I can drop it off at a depot.

it's already sitting on a skid, would just need to strap it down and send a box of bits along with it.