Here is my 2001 Mitsubishi Evo 7 GSR.
== Mods ==
Aftermarket Exhaust
Larger Wastegate
HKS Air filter
Blow off valve
Bigger Intercooler
Ralliart dashboard cluster
HKS camshaft
Evo 9 front bar
Fiberglass hood (May get CF, idk yet)
Pretty sure it has aftermarket CAI as well.
..and tuned in April to put out 233 awkw.
Finally Pulled the Trigger...
Moderators: IMC, Club Staff
- Strkszone
- Grease Monkey
- Posts: 346
- jedwabna poszewka promocja
- Joined: Mon May 05, 2014 5:19 pm
- Location: Wollongong, NSW
- bjk
- Totes
- Posts: 5748
- Joined: Tue Oct 04, 2011 1:34 pm
- Location: Adelaide
Re: Finally Pulled the Trigger...
Nice, what did you pick it up for?
- rock_it
- Oldtimer
- Posts: 6599
- Joined: Sun Jun 10, 2007 5:00 pm
- Location: The Shire .. NSW
- Contact:
Re: Finally Pulled the Trigger...
Looks good man..
Just make sure that bonnet latch is reinforced. Would hate for it to fling up like my old one did..
Just make sure that bonnet latch is reinforced. Would hate for it to fling up like my old one did..
I just had to add it ......
sublime19 wrote:Lol clearly you don't know me well enough, it was a joke
I talk a lot of sh*t, usually have to keep a roll of toilet paper handy in the car for my mouth
Astron_Boy wrote:Hold me Sooty, I need man comfort.
- Strkszone
- Grease Monkey
- Posts: 346
- Joined: Mon May 05, 2014 5:19 pm
- Location: Wollongong, NSW
Re: Finally Pulled the Trigger...
Bit over $14kbjk wrote:Nice, what did you pick it up for?
Yeah the bonnet did look a little bit wobbly (when lifted up). There are a few bits that aren't supported, like the air filter is just sort of sitting there wobbling. I'm going to make sure everything is secured before doing any spirited driving, but it's like nothing I've ever driven before so it will take me a while before I get used to the thing.rock_it wrote:Looks good man..
Just make sure that bonnet latch is reinforced. Would hate for it to fling up like my old one did..
- bjk
- Totes
- Posts: 5748
- Joined: Tue Oct 04, 2011 1:34 pm
- Location: Adelaide
Re: Finally Pulled the Trigger...
Can only guess it's a slight faster than the FTO. Are you going to get this one wrapped as well?
- Strkszone
- Grease Monkey
- Posts: 346
- Joined: Mon May 05, 2014 5:19 pm
- Location: Wollongong, NSW
Re: Finally Pulled the Trigger...
Yeah... just a bit... >.> ... x]...
I will get it wrapped eventually, but only after getting it detailed and then I'll go with a cheaper wrap like Avery Dennison or Hexis instead of 3M.
I will get it wrapped eventually, but only after getting it detailed and then I'll go with a cheaper wrap like Avery Dennison or Hexis instead of 3M.