Lightbulb - Low beam

rnbboi · Post by **rnbboi** » Fri Aug 04, 2006 9:09 am

Hi guys,

Ive been trying to put my drivers side low beam bulb into the headlight.

However unlike the left hand side where u just insert and twist (locking it into place), the drivers side does not?

Ive noticed that without the cable, the bulb is able to twist in, but once attached to the wire/harness, it cannot?

Any ideas?

Thanks.

noccers · Post by **noccers** » Fri Aug 04, 2006 9:34 am

I don't find that problem at all. Both sides twist in an out quite easily for me, you just have to get them on the right angle

rnbboi · Post by **rnbboi** » Fri Aug 04, 2006 10:28 am

noccers wrote:I don't find that problem at all. Both sides twist in an out quite easily for me, you just have to get them on the right angle

omg?

i just realised that the original bulb was neva in properly after checking it out again. it only locked into 2 places... and when i came to put new globes in, i kept on trying to turn back into that angle (the way the original dodgy 1 was) instead of finding another angle to lock all 3 in...

problem solved... >>so sad<<