mivec head on a GR engine
Posted: Mon May 16, 2005 3:53 pm
is it possible to put a mivec head on a 6A12 non-mivec engine and if so how much and where can i grab one from?
FTO AUSTRALIA
Welcome to the f**king old FTO Australia forums!!
https://ftoaustralia.com/v3/
mivec head on a GR engine
Page 1 of 1
Posted: Mon May 16, 2005 3:55 pm
You'll need 2 of 'em matey
.
Posted: Mon May 16, 2005 6:55 pm
cadburyboii..
is it safe to assume u have a GR?
is it safe to assume u have a GR?
Posted: Mon May 16, 2005 9:29 pm
mivec has variable intake and exhaust cams so the short answer is no...
there are also variable intake runners and a ton of other stuff that go into a mivec engine....
if you were even going to consider this as a viable option then i recommend dropping in a mivec engine you'll save a heap of money
there are also variable intake runners and a ton of other stuff that go into a mivec engine....
if you were even going to consider this as a viable option then i recommend dropping in a mivec engine you'll save a heap of money
Posted: Wed May 18, 2005 4:32 pm
I know someone had fitting a GR block with MIVEC head, as the block are exactly the same, all those variable inlet....etc are part of MIVEC head, so I don't see why you can't do it.
Posted: Thu May 19, 2005 5:15 am
So it will work fine. Are you sure there FTO338? And you ll only need half an engine. Hmm. Nice. I'll add it to my to do list.
Posted: Thu May 19, 2005 7:08 pm
I'm am very sure, as I've seen this person & his FTO a lot of time since he done it, & the car run just like any other MIVEC motor from the factory.