Car starts to shake :S

Got a problem with your FTO? ask about it here

Moderators: IMC, Club Staff

eThix
Veteran Mechanic
Posts: 1046
jedwabna poszewka promocja
Joined: Mon Feb 12, 2007 6:00 pm
Location: Brisbane

Car starts to shake :S

Post by eThix »

Ok after driving my car around for about 10 mins or more.
and then when i have to stop in first gear my hole engine starts shaking causing the car to shake with it....
My car will soon go into limp mode.
i got the error codes 41,42,43 but why does my car shake when in 1st gear :S??
what will i need to do to fix this?
User avatar
mr-charisma
Oldtimer
Posts: 4020
Joined: Wed Jul 06, 2005 5:00 pm
Location: Brisbane, Australia

Post by mr-charisma »

what will i need to do to fix this?
Take you car down to Joe & Ricks ;)

Call the insurance company to let them know your car is having all these probs since the accident which weren't there previously, it should also be covered by your insurance, not just the body work.

The engine shaking could be that your engine mounts were damaged in the accident ... get it own to J&R's & make the insurance pay for a tow truck if you need it.
User avatar
jonowong
Oldtimer
Posts: 3420
Joined: Thu Jan 15, 2004 6:00 pm
Location: Sydney

Post by jonowong »

41 Injector system
42 Fuel Pump
43 EGR
eThix
Veteran Mechanic
Posts: 1046
Joined: Mon Feb 12, 2007 6:00 pm
Location: Brisbane

Post by eThix »

jonowong wrote:41 Injector system
42 Fuel Pump
43 EGR
Think these would be related to the crash i recently had?
and is it safe driving it? until it goes into Limp mode?
User avatar
Delvance
Veteran Mechanic
Posts: 1194
Joined: Wed Nov 15, 2006 6:00 pm
Location: Sydney South

Post by Delvance »

I doubt it'd be related to a recent crash ? It was just a minor one right ? And i wouldn't be driving the car if it were showing pump and injector problems either, fuel starvation is not good! Get your fuel path checked out from pump all the way to injector. If it is something wrong with those items, you can easily pick up a 2nd hand pump or something, clean the injectors and would be a good time to change your fuel filter too. Not expensive, just a little time consuming.
The EGR part isn't promising though =/
eThix
Veteran Mechanic
Posts: 1046
Joined: Mon Feb 12, 2007 6:00 pm
Location: Brisbane

Post by eThix »

damn :( ok well there is no way i can make it to joe and ricks, does any one know of a decent enough place to take my car to?
eThix
Veteran Mechanic
Posts: 1046
Joined: Mon Feb 12, 2007 6:00 pm
Location: Brisbane

Post by eThix »

I just got a call from my mate, and said if the stupid panel beater painted over where the battery wire needs to earth to then thats why i'm getting all my problems.
no one say "no thats not it" or i will cry.
i guess i will find out tonight and let use know :)
User avatar
jonowong
Oldtimer
Posts: 3420
Joined: Thu Jan 15, 2004 6:00 pm
Location: Sydney

Post by jonowong »

thats funny but no thats not it
eThix
Veteran Mechanic
Posts: 1046
Joined: Mon Feb 12, 2007 6:00 pm
Location: Brisbane

Post by eThix »

jonowong wrote:thats funny but no thats not it
noooooooooooo :( i think your right :cry:
so annoyed though... cause my car works fine for about 10 mins.... then i start driving and i notice my car doesn't have any revs at all when in a gear...
User avatar
Bennoz
National President
Posts: 23678
Joined: Fri Jan 21, 2005 6:00 pm
Location: Sydney
Contact:

Post by Bennoz »

I reckon you've eaten up & spat out your torque converter....
eThix
Veteran Mechanic
Posts: 1046
Joined: Mon Feb 12, 2007 6:00 pm
Location: Brisbane

Post by eThix »

Bennoz wrote:I reckon you've eaten up & spat out your torque converter....
But i have revs when i start the car and have it in gear :S
where abouts is the torque converter?
lol maybe its time for a manual conversion.
User avatar
payaya
Oldtimer
Posts: 3670
Joined: Sat Sep 06, 2003 5:00 pm

Post by payaya »

what colour is your tranny fluid???
User avatar
SchumieFan
Oldtimer
Posts: 5875
Joined: Thu Aug 05, 2004 5:00 pm
Location: GPS signal lost
Contact:

Post by SchumieFan »

its nothing to do with fluid, its definatly electrical, could be a short even.

without being with the car all i can say is check every cable, but if it shakes like that id say o2 or tourque sensor is smoked and it doesnt know your revs and is starving your engine of fuel (hence the shudder) then going "oh sh*t ive got a problem" and going into limp mode


anyone else?
Image
eThix
Veteran Mechanic
Posts: 1046
Joined: Mon Feb 12, 2007 6:00 pm
Location: Brisbane

Post by eThix »

payaya wrote:what colour is your tranny fluid???
it was black... but i changed it hoping to fix the problem.
eThix
Veteran Mechanic
Posts: 1046
Joined: Mon Feb 12, 2007 6:00 pm
Location: Brisbane

Post by eThix »

SchumieFan wrote:its nothing to do with fluid, its definatly electrical, could be a short even.

without being with the car all i can say is check every cable, but if it shakes like that id say o2 or tourque sensor is smoked and it doesnt know your revs and is starving your engine of fuel (hence the shudder) then going "oh sh*t ive got a problem" and going into limp mode


anyone else?
But if thats the case wouldn't it shake straight away when i turn my car?? because right now i have to drive my car around for about 5-10 mins and then it will start shaking.... but the weird thing is if i leave my car on for 30mins nothing will happen... the car will work fine :cry:
User avatar
Ther
Grease Monkey
Posts: 337
Joined: Mon Jun 21, 2004 5:00 pm
Location: Sydney- Inner West

Post by Ther »

i've got a similar problem, after driving for a while my car, when i stop at the lights, the car starts to shudder....if i put it in N then the shaking stops, once i;m driving its ok but once i stop again the same thing. I pulled over and the shaking is clear from the engine as it starts to shake quite a bit while is in drive (1st gear). Any suggestions?
eThix
Veteran Mechanic
Posts: 1046
Joined: Mon Feb 12, 2007 6:00 pm
Location: Brisbane

Post by eThix »

If you quickly try drive home do you get stuck in LIMP mode?? (3rd gear)
and what error codes you get??
User avatar
Ther
Grease Monkey
Posts: 337
Joined: Mon Jun 21, 2004 5:00 pm
Location: Sydney- Inner West

Post by Ther »

eThix wrote:If you quickly try drive home do you get stuck in LIMP mode?? (3rd gear)
and what error codes you get??
driving isn't a problem, and mivec kicks in no worries at all.. it only happens after driving for a while and while stationary and in gear..

i'll try to check the error codes tonight
eThix
Veteran Mechanic
Posts: 1046
Joined: Mon Feb 12, 2007 6:00 pm
Location: Brisbane

Post by eThix »

Ther wrote:
eThix wrote:If you quickly try drive home do you get stuck in LIMP mode?? (3rd gear)
and what error codes you get??
driving isn't a problem, and mivec kicks in no worries at all.. it only happens after driving for a while and while stationary and in gear..

i'll try to check the error codes tonight
Cool that would be grate! maybe we can find out whats wrong....
do you drive a manual or Tip?
User avatar
Storm
Veteran Mechanic
Posts: 841
Joined: Wed Feb 01, 2006 6:00 pm

Post by Storm »

Error codes 41, 42 & 43 are related to the gearbox in this case, or it wouldn't go into safety mode. They relate to incorrect gear ratios which means you input speed sensor and your output speed sensor are not matching up. One of them is going tits up so you need to swap them with someone elses so you can see which one it is.

Either that or give them a good clean and that might help a bit.
Post Reply